Exmark Lazer ZCT Uživatelský manuál

For Serial Nos. 600,000 & HigherPart No. 109-2279 Rev B.

5 DANGER POTENTIAL HAZARD ♦ Mowing on wet grass or steep slopes can cause sliding and loss of control. WHAT CAN HAPPEN ♦ Wheels dropping over edge

6 WARNING POTENTIAL HAZARD ♦ There is no rollover protection when the roll bar is down. WHAT CAN HAPPEN ♦ Wheels dropping over edges, ditches, st

7 1.4.16 This mower was designed for one operator only. Keep all others away from mower during operation. 1.4.17 Do Not mow with the discharge de

8 WARNING POTENTIAL HAZARD ♦ Hydraulic fluid escaping under pressure can penetrate skin and cause injury. WHAT CAN HAPPEN ♦ Fluid accident

9 PART NO. 1-403005 LOCATION: Left and Right Corners of Mower Deck PART NO. 1-303508 LOCATION: Front Ri

10 2. SPECIFICATIONS 2.1 MODEL NUMBER: Serial Nos. 600,000 & Higher: LCT18BV483; LCT21BV523; LCT23BV6

11 2.3.2 Type of Fuel: Regular unleaded gasoline, 87 octane or higher. 2.3.3 Fuel Filter: Replaceable in-line Briggs and Stratton P/N 493629

12 2.7 HYDROSTATIC GROUND DRIVE SYSTEM 2.7.1 Hydrostatic Pumps: Two Hydro Gear BDP-10A variable displacement piston pumps. 2.7.2 Wheel Motors:

13 2.10.2 Overall Length: 48” Deck 52” Deck 60” Deck Roll Bar - Up 73.9 in. (187.7 cm) 75.5 in. (191.8 cm) 77 in. (195.6 cm) Roll Bar - Down 79

14 FIGURE 2 MOTION CONTROL POSITIONS By moving both levers an equal amount forward or back from the neutral position

i WARNING POTENTIAL HAZARD ♦ This product is a piece of power equipment. WHAT CAN HAPPEN ♦ Failure to follow safe operating practices ca

15 3.1.4 PTO Engagement Switch: Located on the right tank. Switch must be pulled out to the “ROTATE” position to engage the blades. Switch is

16 3.2 PRE-START 3.2.1 Fill fuel tank. For best results use only clean, fresh regular grade unleaded gasoline with an octane rating of 87 or high

17 DANGER POTENTIAL HAZARD ♦ An uncovered discharge opening will allow objects to be thrown in an operator’s or bystander’s direction. Also, conta

18 WARNING POTENTIAL HAZARD ♦ Loading a unit on a trailer or truck increases the possibility of backward tip-over. WHAT CAN HAPPEN ♦ Backward tip

19 WARNING POTENTIAL HAZARD ♦ The engine can become very hot. WHAT CAN HAPPEN ♦ Touching a hot engine can cause severe burns. HOW TO AVOID THE HA

20 a) Check the voltage of the battery with a digital voltmeter. Locate the voltage reading of the battery in the table below and charge the batt

21 3) Install blade bolt and spring disc washer. Be sure the spring disc washer cone is installed towards the bolt head. Place a block of wood betwee

22 b) Check kill circuits. Run engine at one-third throttle, disengage parking brake and raise off of seat (but do not get off of machine) engine

23 4.1.11 Check hydraulic oil level: Service Interval: 40 hr. a) Stop engine and wait for all moving parts to stop. b) Clean are

24 LUBRICATION CHART FITTING LOCATIONS INITIAL PUMPS NO. of PLACES SERVICE INTERVAL 1. Front Caster wheel hubs w/o Zerk ∗0 2 ∗yearly 2. Front Ca

ii EXMARK PARTS PLUS® PROGRAM EFFECTIVE DATE: September 1, 1995 Program If your Exmark dealer does not have the Exmark part in stock, Exmark will

25 h) Insert the assembled nut and axle into the wheel on the side of the wheel with the new seal and bearing. i) With the open end of the w

26 4.1.21 Check spark plug: Service Interval: 160 hrs. a) Remove spark plug, check condition and reset gap, or replace with new plug.

27 4.1.25 Fuel Tank – mounting hardware specification. When installing the nuts onto the fuel tank studs, fully tighten the nyloc nut and back

28 f) To transport, move lever back up to transport (or 4.5” (11.4 cm) cutting height) position. g) Adjust anti-scalp rollers for Normal Op

29 FIGURE 7 SWIVEL ADJUSTMENT SPRING COMPRESSION ADJUSTMENT j) Recheck that blocks fit just snugly under the deck skirt and tha

30 f) Turn the linkage until the distance from the lower front corner of the brake bar measures 1” (2.5 cm) to 1 5/16”(3.3 cm), depending on the type

31 4.2.8 Electric Clutch Adjustment: No adjustment necessary. 4.2.9 Reverse Indicator Adjustment: a) Stop engine, wait for all moving pa

32 TURN BOLTHERELOOSEN HERE(LEFTHAND THREAD)END OFSLOTREVERSEINDICATORTURN HERETO ADJUSTLOOSENHERELOOSEN HERE(RIGHTHAND THREAD)YOKE c) Run the un

33 5. WASTE DISPOSAL 5.1 MOTOR OIL DISPOSAL Engine oil and hydraulic oil are both pollutants to the environment. Dispose of used oil at a certi

34 e) Make sure the parking brake is set and motion control levers are moved out (neutral lock position). f) Check that the PTO is disengage

iii CONGRATULATIONS on the purchase of your Exmark Mower. This product has been carefully designed and manufactured to give you a maximum amount

35 7. BRIGGS & STRATTON ELECTRICAL DIAGRAM

36 8. HYDRAULIC DIAGRAM

37 9. 2-Year Limited Warranty Exmark Turf Equipment (For units purchased on or af

- 38 - 10. Evaporative Emission Control Warranty Statement California Evaporative Emission Control Warranty Statement Your Warranty Rights an

- 39 - NOTES

- 40 - NOTES

- 41 - SERVICE RECORD Date Description of Work Done Service Done By

- 42 -

®MFG. CO. INC. SEE EXMARK’S COMPLETE LINE OF ACCESSORIES RIDING ACCESSORIES CUSTOM RIDE SEAT SUSPENSION SYSTEM DECK LIFT ASSIST KIT HITCH KIT LIGH

iv TABLE OF CONTENTS 1. SAFETY PAGE 1.1 Safety Alert Symbol...

1 1. SAFETY 1.1 SAFETY ALERT SYMBOL This SAFETY ALERT SYMBOL is used both in this manual and on the machine to identify important safety messag

2 1.3.4 Thoroughly inspect the area where the equipment is to be used and remove all stones, sticks, wires, bones, and other foreign objects which

3 DANGER POTENTIAL HAZARD ♦ In certain conditions gasoline is extremely flammable and highly explosive. WHAT CAN HAPPEN ♦ A static charge

4 1.4 OPERATION Although hazard control and accident prevention partially are dependent upon the design and configuration of the equipment, these