Exmark CD42CD Uživatelský manuál

For Serial Nos. 510,000 & Higher Part No. 103-8614 Rev. A

5 c) Raise seat and install drive shaft onto jackshaft (See Figure 2). FIGURE 2 JACKSHAFT AND DRIVE SHAFT CONNECTION d) Align de

6 FIGURE 5 DECK SPRING INSTALLATION h) Un-latch deck from raised position, slowly lower deck to ground and lock deck locking pins

7 4.1 DECK RAISING AND LOWERING 4.1.1 Raising the Mower Deck into Service Position: a) Stop engine, wait for all moving parts to stop a

8 b) Push deck locking pins inward and rotate forward to securely lock deck in lowered position. See Figure 6. WARNING POTENTIAL H

9 CAUTION POTENTIAL HAZARD ♦ Operating a mower deck with loose or weakened blade bolts can be dangerous. WHAT CAN HAPPEN ♦ A loose or weakened blad

10 GREASE FITTING LUBRICATION CHART FITTING LOCATIONS INITIAL PUMPS NO. of PLACES SERVICE INTERVAL 1. Drive Shaft 1 3 40 hours 2. Front Caster Wh

11 n) Re-install the seal guards over the wheel hub and insert wheel into caster fork. Re-install caster bolt and tighten nut fully. IMPORTANT:

12 4.3.2 Deck Leveling: a) Position mower on a flat surface. b) Stop engine, wait for all moving parts to stop, and remove key.

13 5. PARTS LIST 5.1 DECK GROUP Item Part No. Description Qty. 1 1-403005 Danger, Decal...2 2 1-413425

14 5.1 DECK GROUP

ii EXMARK PARTS PLUS® PROGRAM EFFECTIVE DATE: September 1, 1995 Program If your Exmark dealer does not have the Exmark part in stock, Exmark wil

15 5.2 FRONT FRAME GROUP Item Part No. Description Qty. 1 1-303334 Washer, Spring Disk 5/16...2 2 1-513810 Bushing, Flan

16 5.2 FRONT FRAME GROUP

17 5.3 GEARBOX COMPONENTS FOR 103-3460 & 103-3387 Item Part No. Description Qty. 1 109-0188 Asm,

- 18 - 6. 2-Year Limited Warranty Exmark Turf Equipment (For units purchased on o

®MFG. CO. INC.SEE EXMARK’S COMPLETE LINE OF ACCESSORIES RIDING ACCESSORIES CUSTOM RIDE SEAT SUSPENSION SYSTEM DECK LIFT ASSIST KIT HITCH KIT LIG

iii WARNING POTENTIAL HAZARD ♦ This product is a piece of power equipment. WHAT CAN HAPPEN ♦ Failure to follow safe operating p

iv CONGRATULATIONS on the purchase of your Exmark Navigator Cutting Deck. This product has been carefully designed and manufactured to give you

v TABLE OF CONTENTS 1. SAFETY PAGE 1.1 Safety Alert Symbol...

1 1. SAFETY 1.1 SAFETY ALERT SYMBOL This SAFETY ALERT SYMBOL is used both in this manual and on the unit to identify important safety messages

2 1.3.3 While mowing, always wear substantial footwear and long trousers. Do not operate equipment when barefoot or when wearing open sandals. 1

3 1.6.5 Safety signs may be affixed by peeling off the backing to expose the adhesive surface. Apply only to a clean, dry surface. Smooth to rem

4 2. SPECIFICATIONS 2.1 MODEL NUMBER: CD42CD; CD48CD 2.2 DIMENSIONS 42” Deck 48” Deck Overall Width 43.2” (109.7 cm) 49.2” (125.0 cm) Overal