Exmark LAZER ZTM Uživatelský manuál

- 5 -1.5.2 When making adjustments while the engine is running, such as carburetor andmotion control linkage adjustments, stand to one side and keep c

- 6 -1.6 SAFETY SIGNS1.6.1 Keep all safety signs legible. Remove all grease, dirt and debris from safetysigns and instructional labels.1.6.2 Safety s

- 7 -PART NO. 303293LOCATION: On Top of FuelTanksPART NO. 653245LOCATION: Center of ConsoleCAUTIONRELEASEPPDISENGAGE PTO, ENGAGE PARK BRAKE, SHUT OFF

- 8 -2. SPECIFICATIONS2.1 MODEL NUMBER:Serial Nos. 160,000 & Higher: LHP4417KA; LHP4818KCSerial Nos. 190,000 & Higher: LHP4418KCSerial Nos

- 9 -2.4.2 Charging Capacity: 15 amps2.4.3 Battery Type: BCI Group U12.4.4 Battery Voltage: 12 Volt2.4.5 Polarity: Negative Ground2.4.6 Fuses: Tw

- 10 -2.7.5 Hydraulic Filter: Replaceable cartridge type.P/N 513211: 10 microns, 18 psi bypass (Summer use above 32° F)P/N 523541: 40 microns, 18 psi

- 11 -2.10.4 Tread Width: (center to center of tires, widthwise)w/44” Deck w/48” Deck w/52” DeckDrive Wheels34.4 in. (87.4 cm) 36.4 in. (92.5 cm) 38.

- 12 -If the levers do not align with each other, when in the neutral position,(See Fig 2) loosen the hardware and make the appropriate adjustment bys

- 13 - DANGERPOTENTIAL HAZARD♦ Charging the battery may produce explosive gassesWHAT CAN HAPPEN♦ Battery gasses can explode causing serious inj

- 14 - 3.9 SERVICE HYDRAULIC OILThe machine is shipped with hydraulic oil filled to the top of the baffle in reservoir. Runthe machine for approxim

i WARNINGThe engine exhaust from this productcontains chemicals known to the State ofCalifornia to cause cancer, birth defects,or other repro

- 15 - CAUTIONPOTENTIAL HAZARD♦ Machine can spin very rapidly by positioning one levertoo much ahead of the other.WHAT CAN HAPPEN♦ Operator

- 16 -The fuel shut-off valve is used to shut off the fuel when the machine will not beused for a few days, during transport to and from the jobsite,

- 17 -4.2.2 Make sure you understand the controls, their locations, their functions, andtheir safety requirements.4.2.3 Refer to Maintenance, Section

- 18 - CAUTIONPOTENTIAL HAZARD♦ This unit does not have proper turn signals, lights,reflective markings, or a slow moving vehicle emblem.The

- 19 -Ramp should be long enough so that the angles between the ramp and theground and the ramp and the trailer or truck do not exceed 15°. A steeper

- 20 -5.1.3 Clean grass build-up under deck. Service Interval: Dailya) Stop engine and remove key.b) Raise deck to the transport (4.5” cutting height

- 21 -5.1.5 Check safety interlock system.Service Interval: Dailya) Check starting circuit. Starter should crank with operator in seat,parking brake

- 22 -c) Remove foam pre-cleaner element and wash in warm water withdetergent. Rinse until all traces of detergent are eliminated and squeezeout exces

- 23 -5.1.10 Check tire pressures:Service Interval: 40 hrs.a) Stop engine and remove key.b) Inflate all four tires to 13 psi (90 kPa).5.1.11 Check bat

- 24 -c) Lubricate front caster pivots once a year. Remove hex plug and cap.Thread grease zerk in hole and pump with grease until it oozes outaround

iiEXMARK PARTS PLUS PROGRAMEFFECTIVE DATE: September 1, 1995ProgramIf your Exmark dealer does not have the Exmark part in stock,Exmark will get t

- 25 -5.1.19 Check spark plugs:Service Interval: 160 hrs.a) Remove spark plugs, check condition and reset gaps, or replace withnew plugs. See Engine O

- 26 -5.1.23 Fuel Tank – mounting hardware specification.When installing the nuts onto the fuel tank studs, fully tighten the nyloc nut andback off 1/

- 27 -FIG. 6ANTI-SCALP ROLLER ADJUSTMENT5.2.2 Deck Leveling:a) Position mower on a flat surface.b) Stop engine and remove key.c) Check tire pressure o

- 28 -j) Recheck that blocks fit just snugly under the deck skirt and that thetension on all the chains are approximately equal. Make sure all chainat

- 29 -5.2.7 Brake Adjustment.a) Check for brake link 2.75” measurement as described insection 5.2.6.b) Engage brake lever (lever up).c) Measure the d

- 30 -5.2.11 Motion control linkage adjustment. WARNINGPOTENTIAL HAZARD♦ Engine must be running and drive wheels must beturning so motion c

- 31 -FIG. 10MOTION CONTROL ADJUSTMENTf) Start engine. Brake must be engaged and motion control levers outto start engine. Operator does not have to b

- 32 -6. WASTE DISPOSAL6.1 MOTOR OIL DISPOSALEngine oil and hydraulic oil are both pollutants to the environment. Dispose of used oilat a certified

- 33 -6.3 BATTERY DISPOSALDANGERPOTENTIAL HAZARD♦ Battery electrolyte contains sulfuric acid, which ispoisonous and can cause severe burnsWHAT CAN H

- 34 -e) Check that the blades are disengaged.f) Check that the spark plug wires are properly connected.g) Check for loose or faulty wiring connection

iiiCONGRATULATIONS on the purchase of your Exmark Mower. This product has been carefullydesigned and manufactured to give you a maximum amount of depe

- 35 -8. ELECTRICAL DIAGRAM

- 36 -9. HYDRAULIC DIAGRAM

- 37 -10. WARRANTYLimited Warranty Exmark Commercial Turf Equipment Exmark Mfg. Co. Inc. ("Exmark")warrants on the terms and conditions here

- 38 -or persons other than an authorized Exmark service dealer or the installation of parts other thangenuine Exmark or Exmark recommended parts.As a

- 39 -NOTES

- 40 -NOTES

- 41 -SERVICE RECORD Date Description of Work Done Service Done By

- 42 -

®MFG. CO. INC.SEE EXMARK’S COMPLETELINE OF PRODUCTS FOR TURF CARELAZER Z™LAZER Z™ HPTURF RANGER®TURF TRACER®TURF TRACER® HPVIKING HYDROMETRO™METRO™ HP

ivTABLE OF CONTENTS1. SAFETY PAGE1.1 Safety Alert Symbol ... 11.2 Tr

- 1 -1. SAFETY1.1 SAFETY ALERT SYMBOLTHIS SAFETY ALERT SYMBOL IS USED BOTH IN THIS MANUAL AND ONTHE MACHINE TO IDENTIFY IMPORTANT SAFETY MESSAGES WH

- 2 - WARNINGPOTENTIAL HAZARD♦ Engine exhaust contains carbon monoxide, which isan odorless deadly poison.WHAT CAN HAPPEN♦ Carbon monoxide

- 3 - DANGERPOTENTIAL HAZARD♦ In certain conditions gasoline is extremely flammableand highly explosive.WHAT CAN HAPPEN♦ A static charge ca

- 4 -1.4.5 Use EXTREME caution when backing up. LOOK BEHIND YOU!!1.4.6 Stop the blades when crossing surfaces other than grass; and whentransporting